How To Replace Camera Lens On Galaxy Note 5

Introduction

To supercede the sixteen megapixel rear-photographic camera, follow the steps to remove all previous components required. Accept full precaution when operating tools such as heat guns, as they tin can cause potential health hazards.

Insert your fingernail or plastic opening tool into the divot at the top of the rear-facing camera.

Insert your fingernail or plastic opening tool into the divot at the top of the rear-facing camera.
Gently pry and twist the flexible rear cover off the back of the phone.

Insert a fingernail or plastic opening tool into the recess in the bottom right corner of the battery and lift upward.

Insert a fingernail or plastic opening tool into the recess in the bottom right corner of the battery and lift upward.
Remove the battery away from the phone.

Use your fingers to remove the SIM card

Brand sure the battery, the SIM card, and the MicroSD carte have been removed. If these components are not removed, they may get damaged when the heat is practical.
In this step you'll be using a heat gun. The estrus gun operates at high temperatures, and information technology may harm you or the device if non used appropriately. Delight follow the heat gun safety procedures indicated in it's manual to prevent any harm.
Use a heat gun at an approximate distance of 2-3 inches from the phone to utilise heat to the telephone and loosen upwardly the adhesive in the display.

Starting from the upper left corner, insert a guitar option in betwixt the display and the phone case.

Use the pick to pry the brandish by sliding the pick in the direction shown.
Brand sure you lot pry the display around the border of the phone. At the bottom of the screen there is a thin metallic strip that connects the display to the motherboard, and information technology tin be easily damaged.
If whatsoever resistance is encountered, stop prying and reapply heat to go along prying.

Employ the selection to pry the sides and lower part of the brandish by sliding the selection through the phone.
If any resistance is encountered, stop prying and reapply heat to continue prying.

Using the guitar selection, lift the screen slightly.
You tin can remove the domicile push if desired.

Slightly lift, only practice not remove, the upper terminate of display assembly.
Exercise non remove the front end panel entirely. It is still attached past a connector.
If you are reusing the home push flex cable, exist conscientious not to sever the cable from the domicile button. Adhesive tin can cause the cable to rip apart from the domicile button. While the domicile push volition even so work, the fingerprint scanner will not.

Employ the precipitous tip of a guitar pick to lift the front panel assembly cable connector straight up off its socket on the motherboard.
Safely remove the front console assembly from phone.